[tp widget="default/tpw_default.php"]

how to assemble fishing reel插图

How to assemble a fishing rod and reel?

Assembling your Rod and Reel 1. Identify the parts of your fishing pole. A fishing rod can be a complex piece of equipment so it is wise to learn the… 2. Clean the rod beforehand. Wipe both pieces down with a cloth to remove any dirt or debris that could scratch it. 3. Bring the pieces together. …

How do you thread a fishing reel with line?

Thread the line through the guides. Most rods have four to five guides, or eyelets, attached to the rod. Starting at the eyelet closest to the reel, thread it with the line starting at the bottom and coming out of the top. Work your way up to the top of the rod.

How to spool a fishing reel?

Spooling Your Reel Close the bail and place the spool on the floor. Pinch the line and slowly crank the reel. Continue to crank the reel to load the line. Fill the spool until it is 1?8 in (0.32 cm) away from the rim. Use line cutters to cut the line close to the supply spool. Secure the line on the spool.

How to tighten a fishing reel?

Next you will want to attach your reel. For this, you will look on the lower piece of your rod for where you will tighten in your reel. Take the reel arm and place it into the opening of the reel seat and turn the rotating piece counterclockwise until the real arm is firmly locked into the real seat.

How to pull arbor knots?

Pull the arbor knot tight against the spool center and then pull it further so that the “stopper” knot slides up to meet it.

How to tie a fishing line?

Tie a regular overhand knot at the end of your fishing line. Open your bail and wrap your line around the spool center. Then, fix it in place using an arbor knot (see below for how to tie an arbor knot).

What is the ferrule on a fishing pole?

If your fishing pole breaks down into more than one piece for easier transportation, then the ferrule is the section (or sections) where the pole is joined back together. The male ferrule will always slot into the female ferrule. Handle/Grip. This is where you hold the pole when you’re fishing.

How to attach a fishing reel to a pole?

Firstly, you need to attach your reel by placing the mounting handles into the reel seat, one side at a time. The bail will indicate the top of the reel that, when flipped open, should be pointing upwards towards the tip of your pole.

How to make a reel curl?

Place your spool of line on the ground with the label facing upwards and start to crank the reel. The line will want to curl in a particular direction. Make sure that the direction that your reel is turning matches the direction of the line.

What is a guide on a fishing rod?

The guides are the small circles that run down the length of the pole that keeps your line in place, close to the rod. The guides are different based on the type of fishing pole. A fishing rod made for spinning reels will have large guides. The guided will face down toward the ground when the pole is level. Reel.

Where is the arbor on a fishing reel?

The arbor or spool is where the line is stored on the reel. The spool on a spinning reel is on the top of the reel and rotates on the same axis as the fishing pole.

How to attach a reel to a rod?

For this, you will look on the lower piece of your rod for where you will tighten in your reel. Take the reel arm and place it into the opening of the reel seat and turn the rotating piece counterclockwise until the real arm is firmly locked into the real seat. To ensure this, grab the reel and make sure it does not move out of place and there is no room for it to move.

How to use live bait on a minnow?

For live bait such as, worms and minnows, you will open the tab on the end of the leader and attach the hoop on top of the hook, then close tab. If you are looking for more action and technique, you will want to use a lure, this way you can target a direct species and move to different areas of the water faster.

How to cast a reel in a sandbox?

How To Cast: 1. Use your right index finger to grab the line about 3 inches up from the real. 2. Use your left hand to unlock the reel by flicking the semi circle piece of metal to open up the line. 3. Use all your might to fling the line out while letting go of the line. 4.

Why change your leader if you have recently put up a fight with a fish with big chompers?

Make sure to change your leader if you have recently put up a fight with a fish with big chompers because this will weaken and deteriorate the leader

How to make a spooler for fishing line?

One person will need to take a pencil or pen and put it horizontally through the holes of the fishing line container , this will act as a home-made spooler. Holding both ends of the pencil you will slowly let the line unravel as the second person reels in the rod, which wraps the line around the reel. Make sure there is no slack between the container and the reel, this will lower your chances of causing any knots. Keep reeling in until about 3/4 of your reel is filled with line.

How to close a split shot sinker?

Time to grab your handy dandy pliers! You will begin by taking your line and inserting it in the crease of the split shot, then simply apply pressure to the two ends of the split shot sinker opening to bring them together and close it with the line nestled safely inside.

How many pieces are in a fishing rod?

Fishing rods come in varies pieces, some are one piece, most are two piece and others can be 4 pieces. Today we will be focusing on two piece fishing rods.

How Does A Conventional Fishing Reel Work?

A Conventional fishing reel is functioned and controlled by an adjustment knob. When the knob is pressurized, it makes the spool brake system that is placed by the side of the reel faster or slower and enables the spool to release the line. Both the start and lever drag have this configuration.

What Is A Conventional Reel?

Conventional fishing reels are systematically identical to the baitcasting fishing reels, but these are larger in the structure as these reels are used in hunting. And these reels are also known as trolling reels.

How Much Line To Put On A Conventional Reel?

When it comes to putting lines on a conventional reel, it is obvious for you to think over this heated topic because conventional reels require braided lines, and braided lines are nearly non-flexible.

Can You Use A Spinning Rod Without A Conventional Reel?

Yes, certainly you can use a spinning rod without a conventional reel. Spinning rods are particularly made for spinning reels because both are shorter and lighter in size.

What Is The Difference Between A Baitcaster And A Conventional Reel?

A conventional reel and a baitcaster have a lot of similarities, but the application of anglers in saltwater and freshwater has created a difference between them.

How Do You Hold A Conventional Rod?

Holding a conventional rod is easy; all you need to do is place the rod underneath of your arm, holding it tightly, operate the level wind side to side of the reel to spool line.

How long does it take to set up a spinning reel?

With no previous knowledge or skill on spinning rods and reels, this Instructable will take you approximately 30 minutes to complete. However, with a little more experience, setting up your rod and reel will take you just 10 minutes of your time.

What is the reel seat?

The reel seat is the other "puzzle piece" that the reel foot connects to that secures the reel to the rod

What is a line roller?

The line roller accurately guides the line from the spool to the rod

How far above the base of a reel should you hold the rod?

2. Hold the rod a few inches above the base of the reel as well as the line parallel to the rod

When reeling in a fish, should the fish be able to take line from the reel?

It is important to note that when reeling in a fish, the fish should be able to take line from the reel (unless the fish is very small). How tight the drag will be will depend on what type of fish you are fishing for and what type of line you are using.

What is the line cap on a reel?

Some reels have a "Line Cap" marked on their side, telling you the maximum amount of line for the reel

What is the bail on a reel?

The Reel. The bail is a metal arm that can stop the line from coming out of the spool. The drag knob allows you to set how easily line can come out of the spool when the bail is closed. When the know is "tightened", line cannot come out of the spool with the bail closed.

What is it called when a fishing pole breaks?

Identify the parts of your fishing pole. A fishing rod can be a complex piece of equipment so it is wise to learn the terminology before assembling your own. If your rod breaks into 2 parts or more, the joint where the sections fit together is called the ferrule. The male ferrule inserts into a female ferrule.

What is the bale arm on a reel?

The bale arm is the silver overhead piece on the reel. When applying a small amount of pressure, you will be able to flip it up to the other side of the reel. After lifting the bale arm, you will be able to pull the edge of the thread and the reel will unravel it. Use caution here.

How to lock a rod in a rod?

On most rods you will need to rotate the pieces together. Do this by holding the female ferrule and rotating the male piece while they are adjoined. This will lock in your rod.

Which way to thread a rod?

Remember with threading that right is tight and left is loose. When looking at your rod from the back end, threading right will tighten it. In other words, rotating clockwise will tighten the thread, while rotating counter-clockwise will loosen it.

What lures work best for small fish?

A spoon lure will work well for fish that prey on small fish. The spoon will wave back and forth to mimic the movement of a fleeing fish, attracting the bigger predators. If you’re looking for an all-purpose lure, try a spinner. A spinner is a metal piece that will spin in the water as it moves.

How to secure ferrules?

Bring the pieces together. Align the female and male pieces on a flat service. Holding the female ferrule securely, anchor the male ferrule around it. Always ensure that if necessary, any guides to help secure the ferrules are properly aligned.

What do you need to know when setting up a fishing pole?

Regardless of how you like to fish, there are some key elements you must remember when setting up a fishing pole. No matter what type of fish you are hoping to catch, follow basic techniques to ensure your rod is sturdy and lure effective. Steps.

How to tie an arbor knot?

To tie an arbor knot, wrap the line around the arbor and tie an overhead knot in the standing line. Tie a second overhead knot in the tag end, just about 1 in (2.5 cm) from the first overhead knot. Pull the standing line to slide the first knot down to the spool and slide the second knot down to the first.

What to do if your reel is twisting?

If the line is twisting, strip some of the line back off of your reel and realign your spool and line.

What is the opposite direction of a spinning reel?

This is the way the line will be spooled onto the reel; the opposite direction is the way the line will peel off the spool when you cast. Spinning reels are designed to hang down from the rod, not rest above it like spincasting and baitcasting reels are.

How to secure a spool of spool line?

Use an arbor knot to secure the line to the spool. Cut any extra line with line cutters, and make sure that you leave at least a 1?4 in (0.64 cm) of additional line from where you tied the knot. You can also use scissors to cut the line.

How to tell if a fishing reel is clockwise or counterclockwise?

The easiest way to do this is to hold the reel the same way you would if you were actually fishing. Turn the wheel at least 2 to 3 times to determine if the reel turns clockwise or counterclockwise. This is the way the line will be spooled onto the reel; the opposite direction is the way the line will peel off the spool when you cast.

Why should a spool line up?

Your spool should line up so that the line comes off of the spool the same way it will be going into the reel. If your line is twisted or the line doesn’t line up when the label side of the spool is facing up, flip it over. This will help avoid any problems with the line becoming twisted.

What is fluorocarbon line?

This line is also more reactive to light bites and bottom contact. Fluorocarbon lines are considered a type of monofilament line, so they are also great for fishing with jigs, live-bait, or in crystal clear waters. …